INTELLIDOSE COMPLETE AUTO NUTRIENT & PH DISPENSOR

New In Box! AmHydro IntelliDose

The IntelliDose will maintain your pH and nutrient levels, run pumps to your system and data log via PC. Simply program your pH and nutrient settings and the IntelliDose will monitor your reservoir, adding stock solutions as needed to maintain your settings. You can dose up to 8 parts and the unit is PC compatible. Schedule your entire grow cycle in one sitting and data log your progress on your computer. Remote access via PC allows you to check on your system from anywhere, giving you time to do the things you love!

IntelliDose Features:

IntelliDoseâ„¢ controls your nutrient and pH levels for you, on demand.

Doses up to an eight-part nutrient recipe, with the ability to program adjustable ratios for each of the parts.

As plants consume nutrients, NutriDose compensates by adding more nutrient concentrate.

As water levels decrease, NutriDose can balance the ion ratios in your reservoir by adding water (with installed float valve).

Measures in 3 scales, CF, EC or PPM, and can measure from .1 to 99.9 CF / 0-4999 PPM.

Constantly measures pH and adjusts accordingly, either up or down.

Quick and easy pH and Conductivity calibration helps ensure proper measurements.

Monitor and control the IntelliDose using your PC or laptop (certain requirements apply) with the supplied USB cable and software.

On-screen displays make your PC or laptop an incredibly informative console for control of your NutriDose and nutrient tank.

Utilize the data logging feature to track the nutrient uptake, pH fluctuations and temperature changes

Set the alarm for a phone alert via PC modem if something goes wrong

Designate different ratios of your A, B and C nutrients for exact measurements

Automatically adjust your nutrient levels between day and night

Specifications

Outputs:
Eight (8), 12V DC

Nutrient measurement units:
EC, CF or TDS (EC x 500)

Measured range:
EC: 0.00 to 9.99
CF: 0.1 to 99.9
PPM: 0 to 1999

Nutrient resolution:
0.01 mS/cm
0.1 CF

Nutrient measurement accuracy (temperature compensated):
+/- 0.1 EC
+/- 1.0 CF
+/- 10 ppm

Nutrient dosing range:
EC: 0.00 to 5.99
CF: 0.1 to 59.9
PPM: 0 to 1190

pH resolution and accuracy:
– 0.1 pH

pH measurement range:
2 pH to 12 pH

pH dosing range:
5 to 7 pH

Nutrient and pH dosing times:
Settable from 1 second to 30 seconds

Dosing interval:
Settable from 0 minutes (continuous dosing) to 30 minutes
Dosing operates valves sequentially to reduce power surge

Temperature resolution and accuracy:
+/-1° C
+/-2° F

Temperature measurement range:
0-50 °C
32-125 °F

Operating temperature range:
0-50° C
32-125° F
(and not in direct sunlight)

Power source:
12 volt AC transformer pack supplied. Outputs will have the same voltage as the supplied voltage from the power pack.

Large graphics display using simple four key interface (similar to cell phone key operation)

Nutrient sensor uses DiPulseâ„¢ technique to resist fouling

Dosing shut-off:
if nutrient is below 0.1 EC, 1 CF, 10 PPM
if pH is below 4.5 or above 8.0
if dosing effect is counterintuitive, i.e. by dosing pH lower the measured pH goes up
if sensor fault detected

Supplied with PC software and 5 meter USB cable

Can also be supplied with solenoid valve kit or peristaltic pump kit(optional)

IntelliDose Complete comes with the following:

IntelliDose Controller

Sample Pot

pH Probe

PPM Probe

Power Supply

USB Cable (15‘)

Instruction Booklet

Software

All mounting hardware and necessary tubing and fittings

The following accessories are available in out store:

Triple Peristaltic Pump (ID/ND1)

4 Part Solenoid Board for IntelliDose

1 Part Solenoid for IntelliDose/pH Mini Doser

Nutrient Stock Tank Kit - 1 Part

pH Stock Tank Kit - 1 Part

Tank Fitting Kit

Twin Relay Box

Vinyl Tubing for Solenoids (.375 in) - Roll of 50 feet

This is for 1 each New in Box AmHydro IntelliDose Auto Nutrient & pH Dispensor

95031-AmHydro IntelliDose Complete

FOR MORE ENVIRONMENTAL CONTROLLERS THAT WE OFFER, CLICK ON ENVIRONMENTAL CONTROLLERS IN OUR store

» » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » » »

Shipping is paid by the seller in the lower continental US. Shipping is USPS/UPS/FED/X/or best way. I will need your phone# for UPS/Fedx shipping. Shipping is not free to AK and HI. I accept Visa/MasterCard & Paypal. If paying direct with credit card, please call me at 360-691-1001. Thank you!

Buyer to pay with Visa/MasterCard or you may use Paypal. Payment due within 10 days following the end of the sale. Shipping is via USPS/UPS/FEDX or best way and paid by the seller in the lower continental US. Items are shipped within 3 business days upon receiving payment. Email or call 360-691-1001 with any questions before you offer.Thank you!

Be sure to add me to your favorites list!

Design by Sally Milo - GOing1nceLLC

---